PRODUCT AND ORDERING INFORMATION
| Nissan SR20DE 2.0L High Port 4-Cylinder Engine |
The following kit fits the Nissan SR20DE 2.0L High Port 4-Cylinder engine found in these vehicles:
91-93.5 Nissan Sentra SE-R
91-93 Nissan NX2000
91-93 Infiniti G20
NOTE: The kit listed below is for the high port SR20DE engine only. The high port intake has runners above and the plenum and throttle body down low, whereas the low port has the plenum and the throttle body placed above the runners. Check before ordering. Click here to go to the SR20DE Low Port page.
Be sure to determine the correct kit for your style of SR20DE. Click here for help!
) |
ThermoBlok SPACER
KIT - Nissan SR20DE 2.0L High Port
Price: $115.00 plus shipping ($8 US & Canada)
|
){kind=link}
| TESTING RESULTS - Nissan SR20DE 2.0L High Port |
)
This dyno chart shows the results from the installation of a ThermoBlok kit on a '93 Nissan NX2000 with I/H/E, cams, and UD pulleys. The tests were done on the same car and same day, same gear, etc, immediately following the spacer installation. The vehicle was fully warmed up for both tests and no other modifications were done.
RESULTS: maximum gain 9.1 whp and 6.9 ft-lbs of torque.
)
This temp chart shows the temp reduction seen at the intake runners from the installation of a ThermoBlok kit on a '93 Nissan NX2000. The tests were done on the same car during a steady state 50-70 mph drive followed by idle.
RESULTS: Approximately 35°F cooler at cruise and 20°F after idle.
NOTE: Special thanks goes out to Nick McCollum of Cincinnati for the use of his '93 NX2000 for the testing of the Nissan SR20DE High Port ThermoBlok spacers. Thanks Nick!